Ulterius Technologies LLC FDN40 Manual De Usuario
CHAPTER 4: RIP
Configuration User Manual
78
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
4.5.2.1
CLI Configuration
1. Execute the following commands in the switch FDN40-1.
Enter the Global Configuration mode.
UltOs# configure terminal
Enable RIP globally in the switch FDN40-1.
UltOs(config)# router rip
Enable RIP over the interface vlan 1 (IP address 10.0.0.1/16).
UltOs(config-router)# network 10.0.0.1
Exit from the router configuration mode.
UltOs(config-router)# exit
2. View the RIP interface using the following command.
UltOs# show ip rip statistics
RIP Global Statistics:
----------------------
Total number of route changes is 0
Total number of queries responded is 0
Total number of periodic updates sent is 11
Total number of dropped packets is 0
RIP Interface Statistics:
-------------------------
Interface Periodic BadRoutes Triggered
BadPackets Admin
BadPackets Admin
IP Address Updates Sent Received Updates Sent
Received Status
Received Status
----------- ------------ --------- ------------ -
--------- ------
--------- ------
10.0.0.1 11 0 0
0 Enabled
0 Enabled
3. View the RIP route
UltOs# show ip rip database
10.0.0.0/8[1] summary route
10.0.0.0/16 directly connected, vlan1
RIP can be enabled on Pseudo wire interface similar to RIP on router port.
4.5.2.2
WEB Configuration
RIP can be enabled/ disabled on an IP network through WEB interface using
the RIP Interface screen (Navigation - Layer3 Management > RIP >
Interface Configuration)
the RIP Interface screen (Navigation - Layer3 Management > RIP >
Interface Configuration)