Zebra HW46211 Manual De Usuario

Page 3-14

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A 1/24/06

Section 3

Troubleshooting

Printer stops and
ERROR LED flashes.

Printhead is not fully closed.

Close printhead completely.

Head-open sensor not 
detecting position flag, or flag 
is not in the proper position.

Check head-open sensor and 
flag for proper operation.

Printer stops and
ERROR LED flashes.

Printhead element is 
overheated.

Printer resumes printing when 
the printhead element cools to 
normal operating temperature.

Printer stops and
ERROR LED flashes.

Printhead element is not hot 
enough to print properly.

Environment too cold for 
proper printing. Relocate 
printer to warmer area.

Printhead data cable not 
properly connected.

Allow printhead to cool. 
Disconnect and reconnect 
printhead cables. Ensure 
cables are fully inserted into 
connectors.

Print quality problems.

Printhead element is going 
bad.

To override this message, 
place ^JT in your format and 
then ~JO to turn off the HEAD 
TEST.
Clean printhead and test for 
proper printing. Replace 
printhead if necessary.

Cutter blade is
in the media path.

Turn power Off (O). Remove 
media, reload media, and turn 
power On (l). If the error 
condition persists, check 
cutter sensors and control 
board. Replace if necessary.

ERR0R CONDITION

HEAD OPEN

WARNING

HEAD OVERTEMP

WARNING

HEAD UNDERTEMP

ERR0R CONDITION

ELEMENT BAD

ERR0R CONDITION

CUTTER JAMMED