Zebra HW46211 Manual De Usuario
Page 3-16
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 3
Troubleshooting
Fine gray lines on blank
labels at angles.
labels at angles.
Wrinkled ribbon.
Refer to Wrinkled Ribbon
Symptom on
Symptom on
table.
Wrinkled ribbon
Ribbon fed through machine
incorrectly.
incorrectly.
Load ribbon correctly.
Ribbon supply spindle tension
needs adjusting.
needs adjusting.
Perform adjustments.
Incorrect burn temperature.
Set burn temperature to
lowest setting possible for
good print quality.
lowest setting possible for
good print quality.
Incorrect printhead pressure
or balance.
or balance.
Set pressure to minimum
needed. Refer to printhead
balance adjustment and
printhead pressure
adjustment procedures.
needed. Refer to printhead
balance adjustment and
printhead pressure
adjustment procedures.
Media not feeding properly;
walking from side to side.
walking from side to side.
Make sure media is snug by
adjusting media guide.
adjusting media guide.
Strip plate needs adjusting.
Perform adjustments.
Printhead needs realigning
with platen roller.
with platen roller.
Perform adjustments.
Ribbon take-up spindle
tension needs adjusting.
tension needs adjusting.
Perform adjustments.
Three-point mount for ribbon
supply spindle needs
adjusting.
supply spindle needs
adjusting.
Perform adjustments.
Ribbon supply core slipping;
spindle blades need adjusting.
spindle blades need adjusting.
Perform adjustments.
Light printing or no
printing on left or right
side of label.
printing on left or right
side of label.
Printhead needs balancing.
Adjust balance. See printhead
balance adjustment
procedures.
balance adjustment
procedures.
Misregistration or
skipped labels.
skipped labels.
Improper sensor type
selected.
selected.
Perform media sensor
adjustments.
adjustments.
Misadjusted media sensors.
Calibrate printer.
Improper spindle tensions.
Perform spindle adjustments.
Improper ZPL format.
Correct ZPL format.
Table 3-3. Basic Troubleshooting (Continued)
Symptom
Diagnosis
Action