Zebra HW46211 Manual De Usuario

Page 4-8

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Preventive Maintenance

Clean the Zebra Printer

Refer to 

 and perform the preventive maintenance procedures at the prescribed 

interval.

Printhead

Solvent*

After every roll of media (or 500 feet 
[150 m] of fanfold media) when 
printing in Direct Thermal Mode and 
after every roll of ribbon when printing 
in Thermal Transfer Mode.

Platen Roller

Solvent*

Transmissive Media Sensor

Air blow

Reflective (Black-Mark) 
Sensor

Air blow

Media Path

Solvent*

Tear-Off or Peel-Off Bar

Solvent*

As needed.

Snap Plate

Solvent*

As needed.

Take-Label (Label-Available) 
Sensors

Air blow

Monthly.

Ribbon Sensor

Air blow

After every roll.

Ribbon Feeding

Visual inspection After every roll.

Belts

Visual 
inspection:
Look for belt 
wear.

Every 6 months or after every 
500 rolls.

Media Supply Spindle
Media Take-Up Spindle
Ribbon Supply Spindle
Ribbon Take-Up Spindle

The spindle torque should be tested every year, or 
500 rolls of media for the media take-up spindle; and 
every 200 rolls of ribbon for the ribbon supply and ribbon 
take-up spindles.
The spindle torque need not be readjusted unless the 
printer is malfunctioning.

Cutter

Clean stationary cutter blade with solvent* when it 
becomes gummed up with adhesive and cut debris.

After cleaning, apply a small amount of grease to the 
moving cutter parts.

*Zebra recommends a solution containing 90% isopropyl alcohol.

Unless indicated otherwise, turn the printer power Off (O) and disconnect the 
printer from the power source before performing the following maintenance.

Use only the cleaning agents described in the following procedures. Zebra 
Technologies will not be responsible if any other fluids are used on this printer.