Справочник Пользователя для Zebra HW46211
Page 4-8
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Preventive Maintenance
Clean the Zebra Printer
Refer to
interval.
Table 4-1. Recommended Cleaning Schedule
Area
Method
Interval
Printhead
Solvent*
After every roll of media (or 500 feet
[150 m] of fanfold media) when
printing in Direct Thermal Mode and
after every roll of ribbon when printing
in Thermal Transfer Mode.
[150 m] of fanfold media) when
printing in Direct Thermal Mode and
after every roll of ribbon when printing
in Thermal Transfer Mode.
Platen Roller
Solvent*
Transmissive Media Sensor
Air blow
Reflective (Black-Mark)
Sensor
Sensor
Air blow
Media Path
Solvent*
Tear-Off or Peel-Off Bar
Solvent*
As needed.
Snap Plate
Solvent*
As needed.
Take-Label (Label-Available)
Sensors
Sensors
Air blow
Monthly.
Ribbon Sensor
Air blow
After every roll.
Ribbon Feeding
Visual inspection After every roll.
Belts
Visual
inspection:
Look for belt
wear.
inspection:
Look for belt
wear.
Every 6 months or after every
500 rolls.
500 rolls.
Media Supply Spindle
Media Take-Up Spindle
Ribbon Supply Spindle
Ribbon Take-Up Spindle
Media Take-Up Spindle
Ribbon Supply Spindle
Ribbon Take-Up Spindle
The spindle torque should be tested every year, or
500 rolls of media for the media take-up spindle; and
every 200 rolls of ribbon for the ribbon supply and ribbon
take-up spindles.
The spindle torque need not be readjusted unless the
printer is malfunctioning.
500 rolls of media for the media take-up spindle; and
every 200 rolls of ribbon for the ribbon supply and ribbon
take-up spindles.
The spindle torque need not be readjusted unless the
printer is malfunctioning.
Cutter
Clean stationary cutter blade with solvent* when it
becomes gummed up with adhesive and cut debris.
becomes gummed up with adhesive and cut debris.
After cleaning, apply a small amount of grease to the
moving cutter parts.
moving cutter parts.
*Zebra recommends a solution containing 90% isopropyl alcohol.
Caution:
Unless indicated otherwise, turn the printer power Off (O) and disconnect the
printer from the power source before performing the following maintenance.
printer from the power source before performing the following maintenance.
Caution:
Use only the cleaning agents described in the following procedures. Zebra
Technologies will not be responsible if any other fluids are used on this printer.
Technologies will not be responsible if any other fluids are used on this printer.