Zebra HW46211 Manual De Usuario
Page 4-42
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Adjust and Maintain Spindle
There are four spindles that require periodic tension measurement and adjustment.
Measure spindle tension at least once each year (more often if high printer use). Adjust
tension whenever it is not within the tolerance range associated with that spindle.
T
Figure 4-25. Spindle Tension Adjustments
Caution:
Do not disassemble spindle!!!
Ribbon Supply
Spindle Assy
Media Supply
Spindle Assembly
Ribbon Take-up
Spindle Assembly
Media Rewind
Spindle Assemby
Attach polyester
film strip to
ribbon core
with tape.
Loosen the set screws on
the adjusting nut. Turn the
nut in or out to increase or
decrease the force.
After adjustment, secure the
nut to the shaft with the
set screws.
the adjusting nut. Turn the
nut in or out to increase or
decrease the force.
After adjustment, secure the
nut to the shaft with the
set screws.
Align all three sections
before installing ribbon core.
Media
Core
Core
Media
Core
Core
Spindle
(force)
Ribbon Supply
Ribbon Take-up
Media Supply
Media Rewind
450
450
300
1450
±50
±50
±50
±100
(F1)
(F2)
(F3)
(F4)
110
III
Xi Plus
(grams)
Push buttons in.
Pull out the end
cap/release bar
assembly.
F1
F3
F2
F4
Polyester
Tape
Adjusting Nut