Zebra HW46211 Manual De Usuario

13185L-002 Rev. A  1/24/06

110XiIIIPlus Maintenance Manual

Page 4-53

Maintenance

Section 4

18. Slide the small spacer onto the shaft.

19. Slide the rewind platen pulley onto the platen roller and align the set screws with the 

flat surfaces of the platen roller.

20. Leave a gap of approximately 0.020 in. (0.5 mm) between the C-clip and roller 

adjust plate on the right-hand side of the platen roller shaft.

21. Tighten the screws on the rewind platen pulley. Both screws must be on the flat 

portions of the shaft.

22. Reinstall the rewind drive belt.

23. Refer to 

. Reinstall the rewind plate by sliding it onto the print 

mechanism.

24. Refer to the Users Guide and reload the media and ribbon in Peel-Off Mode.

25. Connect the AC power cord and turn the printer On (l).

26. Perform a Pause Key Self Test to check the tracking of the rewind drive belt, liner 

and to examine print quality.

If the liner is tracking off to one side, perform steps 

27. Refer to 

. Loosen the two screws securing the roller adjust plate to the 

print mechanism.

28. Move the roller adjust plate in the appropriate direction to compensate for the 

tracking and tighten the screws. 

29. Repeat steps 

 and 

 until the required results are achieved.

30. Reinstall the electronics cover.

31. Reinstall the communications cable.

Note • Moving the roller adjust plate toward the front of the printer moves the 
liner material away from the roller adjust plate. Moving the roller adjust plate 
toward the rear of the printer moves the liner material toward the roller adjust 
plate.