Zebra HW46211 Manual De Usuario
Page 4-54
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Replace the Cutter Components
Remove and Install the Cutter Main Link
1. Refer to
. Turn the printer Off (O), remove the AC power
cord and data cables.
2. Refer to
and remove the electronics cover.
3. Refer to
and remove the power supply.
4. Refer to
. Remove the E-ring securing the cutter main link to the short
arm side of the cutter slotted link.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
The printer electronics are susceptible to static discharge. Before proceeding, it
is highly recommended the technician wear an antistatic wrist strap connected
to the printer chassis.
is highly recommended the technician wear an antistatic wrist strap connected
to the printer chassis.
Caution:
This installation must be performed by a qualified service technician.
Caution:
Wear protective eyewear when removing E-rings, C-clips, snap rings, and
springs. All of these are under tension and could fly off while being removed.
springs. All of these are under tension and could fly off while being removed.