Zebra HW46211 Manual De Usuario

Page 4-90

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Install the Rewind Option

1. Refer to 

. Place a flat washer (2) onto one of the screws (8). Use the 

Allen wrench provided in the kit to place this mounting screw through the lower 
access hole in the side plate and through the idler pulley mounting slot in the printer 
main frame. On the electronics side of the printer main frame, attach the idler shaft 
(22) to the mounting screw.

2. Position the idler shaft in the middle of the mounting slot and tighten the mounting 

screw. Apply a very small amount of grease (provided in kit) to the idler shaft with a 
toothpick or small screwdriver. Keep excess grease away from other components. 

3. Slide the idler pulley (20), flat side out, onto the idler shaft.

4. In the lower center portion of the main frame, remove the cover plate from the 

rewind spindle mounting hole.

5. Slide the bearing housing assembly (11) out of the media rewind spindle 

assembly (5).

6. Install the bearing housing assembly on the printer main frame using three screws 

(1) and three flat washers (2). Do not tighten the screws at this time.

7. Insert the shaft of the rewind spindle (5) through the bearing housing assembly.

8. Place the wave washer (16), flat washer (15), and pulley, recessed side facing away 

from the main frame, (12) onto the rewind spindle shaft.

9. Slide the spacer (23) on the rewind spindle shaft. Press the E-ring (13) into the 

groove in the rewind spindle shaft.

10. Attach the platen support bracket (7) to the side plate with two flat washers (2) and 

two screws (8). Do not tighten the screws at this time.

11. Remove the plastic plug from the rewind platen mounting hole near the bottom of 

the main frame.

12. Insert the long end of the rewind platen shaft (4) through the rewind platen 

mounting hole.

13. Place the flange bearing (3) over the left end of the rewind platen shaft. Press the 

bearing into the mounting hole with the flange on the outside (left side) of the main 
frame.

14. Place the opposite end of the rewind platen shaft through the platen support 

bracket (7).

15. Place the remaining flange bearing (3) over the right end of the rewind platen shaft 

with the flange of the bearing on the outside (right side) of the platen support 
bracket. Press it into the mounting hole in the platen support bracket and secure with 
the E-ring (9).

16. Use the Allen wrench to tighten the mounting screws that secure the platen support 

bracket to the side plate. The bracket may need adjustment later.

17. Slide the spacer (21) onto the rewind platen shaft.

18. Slide the rewind platen pulley (17) onto the rewind platen shaft and align the two 

pulley set screws with the flat surfaces of the rewind platen shaft.