Zebra HW46211 Manual De Usuario

13185L-002 Rev. A  1/24/06

110XiIIIPlus Maintenance Manual

Page 4-91

Maintenance

Section 4

19. Leave approximately a 0.020 inch (0.5 mm) gap between the E-ring (9) and platen 

support bracket (7), and tighten the set screws. 

20. Position the rewind plate as shown in 

 with the attached hook plate 

pointing down.

21. Insert the hook plate 1/2 inch (13 mm) into the lower opening in the side plate.

22. Align the upper end of the media rewind plate with the corresponding opening in the 

side plate, then slide the rewind plate in until it stops against the main frame.

Install and Adjust the Drive Belt Tension

Refer to 

 and install the rewind drive belt.

Refer to 

 and adjust the rewind drive belt tension.

Refer to 

 and readjust the main drive belt tension.

Rewind Plate

Lip

Adjustable
Hook Plate

Slot

Take-Label
Sensors

Lower Platen
Roller Adjustment
Screws