Zebra HW46211 Manual De Usuario

Page 4-100

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Install External PrintServer II 

Hardware Description

Test Button: This generates a detailed PrintServer II configuration label.

Status Indicator: A bicolored indicator displays the state of the PrintServer II.

Ethernet Connection: Connection for a 10Base-T cable. Connecting the PrintServer II 

does not interrupt network operation.

Parallel Connector: The external PrintServer II is powered by the printer; no additional 

power source is required.

Install the External ZebraNet PrintServer II

1. Turn the printer Off (O). Install the PrintServer II device directly into the parallel 

port on the printer and secure with the wire locks.

2. Insert an active 10Base-T cable into the Ethernet connector on the back of the 

PrintServer II device.

3. Turn the printer power On (l). The status indicator blinks orange during the 

Power-On Self Test phase and changes to green when stabilized.

4. Press the test button on the back of the PrintServer II to print a PrintServer II 

configuration label.

The printer electronics are susceptible to static discharge. Before proceeding, it 
is highly recommended the technician wear an antistatic wrist strap connected 
to the printer chassis.

Parallel

Connector

Test

Button

Status

Indicator

Ethernet

Connector

Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.