Zebra HW46211 Manual De Usuario

Page 4-120

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

11. Refer to 

. Install the cutter optical sensor assembly (7) on the sensor 

mounting post. The sensor part of the assembly should be mounted toward the 
printer frame.

12. Place the sensor clamp (5) over the sensor and start the nut (4) on the post. Do not 

tighten the nut at this time.

13. Route the sensor leads under the clamp and toward the rear of the printer, and lightly 

tighten the nut to hold the wires in position. Be careful not to pinch the wires.

14. Refer to 

. Plug the cutter sensor leads into the cutter opto connector J3 

on the cutter circuit board.

15. Check the installation and ensure that no wiring touches any moving parts.

16. Refer to 

 and align the lower drive arm.

17. Refer to 

 to time the upper drive arm.

18. Refer to 

 and reinstall the AC/DC power supply.

19. Refer to 

 and reinstall the electronics cover.

20. Reconnect the AC power cord.

21. Turn the printer On (l). Enter Configuration Mode and set the printer to Cutter 

Mode. Save as PERMANENT

and turn the printer Off (O). 

22. Load media and ribbon, press and hold PAUSE while turning the printer On (l), and 

run labels through the printer.

23. Test the cutter for proper operation.

Printhead Test Option Kit

Access the Printer

1. Refer to 

. Turn the printer Off (O) and remove the power 

cord. Disconnect the printer communications cable.

2. Refer to 

 and remove the electronics cover.

Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.

This installation must be performed by a qualified service technician.

The printer electronics are susceptible to static discharge. Before proceeding, it 
is highly recommended that the technician wear an antistatic wrist strap 
connected to the printer chassis.