Справочник Пользователя для Zebra HW46211
Page 4-120
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
. Install the cutter optical sensor assembly (7) on the sensor
mounting post. The sensor part of the assembly should be mounted toward the
printer frame.
printer frame.
12. Place the sensor clamp (5) over the sensor and start the nut (4) on the post. Do not
tighten the nut at this time.
13. Route the sensor leads under the clamp and toward the rear of the printer, and lightly
tighten the nut to hold the wires in position. Be careful not to pinch the wires.
14. Refer to
. Plug the cutter sensor leads into the cutter opto connector J3
on the cutter circuit board.
15. Check the installation and ensure that no wiring touches any moving parts.
16. Refer to
and align the lower drive arm.
17. Refer to
to time the upper drive arm.
18. Refer to
and reinstall the AC/DC power supply.
19. Refer to
and reinstall the electronics cover.
20. Reconnect the AC power cord.
21. Turn the printer On (l). Enter Configuration Mode and set the printer to Cutter
Mode. Save as PERMANENT
and turn the printer Off (O).
22. Load media and ribbon, press and hold PAUSE while turning the printer On (l), and
run labels through the printer.
23. Test the cutter for proper operation.
Printhead Test Option Kit
Access the Printer
1. Refer to
. Turn the printer Off (O) and remove the power
cord. Disconnect the printer communications cable.
2. Refer to
and remove the electronics cover.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Caution:
The printer electronics are susceptible to static discharge. Before proceeding, it
is highly recommended that the technician wear an antistatic wrist strap
connected to the printer chassis.
is highly recommended that the technician wear an antistatic wrist strap
connected to the printer chassis.