Zebra HW46211 Manual De Usuario

13185L-002 Rev. A 1/24/06

110XiIIIPlus Maintenance Manual

Page 2-45

Operations Overview

Section 2

Set Applicator Port

Determines the action of the verifier port.

Off: The applicator port is off.

Mode 1: Asserts the ~END_PRINT signal low while the printer is moving the label 

forward.

Mode 2: Asserts the ~END_PRINT signal high while the printer is moving the label 

forward.

Mode 3: Asserts the ~END_PRINT signal low for 20 milliseconds when a label has been 

completed and positioned. Not asserted during continuous printing modes.

Mode 4: Asserts the ~END_PRINT signal high for 20 milliseconds when a label has 

been completed and positioned. Not asserted during continuous printing modes.

Press NEXT/SAVE to display START PRINT SIG.

Set Start Print Signal

This parameter determines how the printer reacts to the Start Print Signal input on pin 3 of 

the applicator interface connector at the rear of the printer. 

Press the right or left black oval key to display other choices.

•

In Pulse Mode, labels print when the signal transitions from HIGH to LOW.

•

In Level Mode, labels print as long as the signal is asserted LOW.

Press NEXT/SAVE to display RESYNCH MODE.

Note • Set as suggested by the applicator manufacturer.

Default: Off

Range: Off, mode 1, mode 2, mode 3, mode 4

APPLICATOR PORT

OFF

Default: Pulse Mode

Range: Pulse Mode, Level Mode

Start Print Signal is set by the applicator manufacturer and should not be 
changed unless the factory defaults have been reloaded. The printer must be 
returned to its designated setting to work properly.

START PRINT SIG

PULSE MODE