Voltcraft LT-100Tester LT-100 Manual De Usuario
Los códigos de productos
LT-100
22
a) Switch on and off the device
the batteries included must be inserted before you are able to use the device. Inserting and
replacing the batteries is described in the chapter “Cleaning and maintenance”.
The device is switched on via the respective functions button on the front side.
The high voltage test and continuity test are only active as long as the corresponding button is kept pressed. The
The high voltage test and continuity test are only active as long as the corresponding button is kept pressed. The
device automatically switches off on releasing the button.
b) Lamp test with antenna sensor
please ensure that no button is pressed on the device. do not touch the antenna during the test
phase. Keep the device below the grip area marking (10). there is the risk of electric shock.
do not touch the lamp with your hand since this could distort the test result.
• On request pull out the antenna sensor to the necessary length.
• Switch off the lighting to be tested. The lamp can remain in the socket or be taken out.
• Insert the arched sensor head centered directly onto the glass pipe of the lamp or onto the side contacts of the
• Switch off the lighting to be tested. The lamp can remain in the socket or be taken out.
• Insert the arched sensor head centered directly onto the glass pipe of the lamp or onto the side contacts of the
light socket (only touch one contact). If necessary change the position of the sensor.
• Press the “TEST “ button and keep this pressed for the duration of the test. The lamp tester specifies an ionizing
high voltage signal at intervals of approximately 1 second. The voltage output is signaled with the red “TEST” (2)
indicator.
• The lamp should start to light up at this interval. If this is not the case the lamp must be replaced.
• Release the “TEST” button. The device switches off.
• Push the antenna back into the device to avoid damage.
• Release the “TEST” button. The device switches off.
• Push the antenna back into the device to avoid damage.