Voltcraft LT-100Tester LT-100 Manual De Usuario
Los códigos de productos
LT-100
23
c) Lamp test with contact test
please ensure that no button is pressed on the device. the antenna should not be pulled out dur-
ing the test phase. Keep the device below the grip area marking (10). there is the risk of electric
shock.
The contact testing of the heating coil is necessary since this is responsible for the ionization of the gas inside the
glass tube.
• Switch off the lighting to be tested and take out the lamp from
• Switch off the lighting to be tested and take out the lamp from
the socket.
• First plug a side of the light socket into the socket until this
noticeably snaps.
• Press the “PIN” button and keep it pressed for the duration
of the test. The lamp tester signals the continuation of the
heating coil with a signal sound. In addition the display “PIN”
lights up red. The continuity test was successful. The socket
can be pulled from the tester.
• A rough measuring value <1 kOhm is recognised as a continuity and the beeping sounds.
• Repeat this test with the opposite contact page.
• A passage must be indicated on both sides. The lamp must be replaced if this is not the case.
• Release the “PIN” button. The device switches off.
• Repeat this test with the opposite contact page.
• A passage must be indicated on both sides. The lamp must be replaced if this is not the case.
• Release the “PIN” button. The device switches off.
8. tOrCh
The LED lighting can be switched on and off independently from the test mode. Briefly press the button for the torch
(6) to switch on the LED light. Push the key once to turn illumination on and twice to turn it back off.
The light remains on until the function is deactivated via the light switch (6) or the automatic switch off (max.
The light remains on until the function is deactivated via the light switch (6) or the automatic switch off (max.
5 minutes).