Mediola FS20 Wireless master slave transmitter 1-channel Max. range (open field) 100 m 1057-97 Hoja De Datos



To understand the following description of the programming
steps, you will need the accompanying flowchart.

The basic operating steps and displays are the same for all programming
steps. You are guided through the operating steps by three displays of the
control indicator (LED) of the ‘FS20 FMS’ that are always repeated.

The LED shows, for how long the button has already been pressed:
• Briefly pressing the button is indicated by the LED lighting up once

• If the button is held down for longer, the LED lights up for approx 2

seconds and then goes out.

• After 5 seconds the LED lights up again.

• After a total of 12 seconds the LED goes out again.

• In the setting modes the LED blinks periodically. The number of blinks

can always be found on the right behind the slash (/) in the flowchart.

In the following section an example of how to set up the device is described
in detail. The settings that follow are described in short-hand with respect
to the flowchart and are, for the most part, meant to be commentary for the
flowchart.
Please note the legend in the upper right-hand corner of the diagram. The
starting point is always the ‘operating mode’ in the upper left-hand corner.
From every set-up mode you can return to the operating mode by pressing
the button for more than 5 seconds without making any changes (escape
function).



If no button is pressed for 60 seconds, then you will also be
returned to the operating mode without any changes being
made.