Texas Instruments Evaluation Kit for FPD-Link Family of Serializer and Deserializer LVDS Devices FLINK3V8BT-85/NOPB FLINK3V8BT-85/NOPB Hoja De Datos
Los códigos de productos
FLINK3V8BT-85/NOPB
FPD-Link Evaluation Kit User’s Manual
National Semiconductor Corporation
Rev 3.0
Date: 9/25/2007
Page 17 of 25
Date: 9/25/2007
Page 17 of 25
Typical Connection / Test Equipment
The following is a list of typical test equipment that may be used to generate signals
for the TX inputs:
1) Graphics card or GUI controller with digital RGB (LVTTL) output.
2) TEK HFS9009 - This pattern generator along with 9DG2 Cards may be used to
generate input signals and also the clock signal.
3) TEK DG2020 - This generator may also be used to generate data and clock
signals.
4) TEK MB100 BERT - This bit error rate tester may be used for both signal source
and receiver.
5) Any other signal / pattern generator that generates the correct input levels as
specified in the datasheet.
The following is a list of typically test equipment that may be used to monitor the
output signals from the RX:
1) LCD Display Panel which supports digital RGB (LVTTL) inputs.
2) TEK MB100 BERT - Receiver.
3) Any SCOPE with 50 Ohm inputs or high impedance probes.
LVDS signals may be easily measured with high impedance / high bandwidth
differential probes such as the TEK P6247 or P6248 differential probes.
The picture below shows a typical test set up using a Graphics Card and LCD Panel.
Digital RGB (TTL)
from Graphic
Contoller
Digital RGB (TTL)
to Panel
Transmitter
Board
Receiver
Board
LVDS Interface
Cable
Graphics
Card
AGP/PCI/ISA Bus
Contents of Demo Kit
LCD Panel
Typical FPD-Link Setup / PC Panel Application