Texas Instruments LM10504 Evaluation Board LM10504EVAL/NOPB LM10504EVAL/NOPB Hoja De Datos
Los códigos de productos
LM10504EVAL/NOPB
LM10504EVAL User Guide
3
LM10504EVAL User Guide
Texas Instruments 4Q 2011
LM10504EVAL User Guide
Evaluation Software
LM10504 evaluation software is supplied together with documentation
regarding the circuit. Copy the folder “lm10504” to your PC’s hard disk.
The software is run by double clicking the icon of lm10504.exe found in the
folder. The software does not require any installation.
regarding the circuit. Copy the folder “lm10504” to your PC’s hard disk.
The software is run by double clicking the icon of lm10504.exe found in the
folder. The software does not require any installation.
The evaluation software allows control of all registers necessary to program
the device. To simplify the use of software, the registers are set by directly
named controls. The user does not need the register value as this is taken
care of by the software. For example, to change LDO3 output voltage to
1.0V, choose the related value and the software will send the correct value
to the LDO3 control register
the device. To simplify the use of software, the registers are set by directly
named controls. The user does not need the register value as this is taken
care of by the software. For example, to change LDO3 output voltage to
1.0V, choose the related value and the software will send the correct value
to the LDO3 control register
Hardware Set Up
Please use ESD protection when handling the evaluation boards to prevent
any damage from ESD events!
any damage from ESD events!
Connect the LM10504 evaluation board to the USB port of a PC using the
USB cable.
USB cable.
When the USB board is plugged in for the first time, the operating system
prompts for
“New hardware found” and installs the USB driver. If this does not happen,
try unplugging and plugging the cable in again.
prompts for
“New hardware found” and installs the USB driver. If this does not happen,
try unplugging and plugging the cable in again.
Always disconnect the USB cable from the computer when changing
jumper settings.
jumper settings.
If the evaluation board is not responding or the evaluation software hangs
up, disconnect the USB cable for 5 seconds.
up, disconnect the USB cable for 5 seconds.
Software Set Up
The graphical user interface has a main screen with two tab screens
(System and Log) which allow control and indication for different functions
of the device.
(System and Log) which allow control and indication for different functions
of the device.
Once the evaluation board is connected to the PC, double click on the GUI
icon and the device can be controlled via the software interface.
icon and the device can be controlled via the software interface.