Texas Instruments LM10504 Evaluation Board LM10504EVAL/NOPB LM10504EVAL/NOPB 데이터 시트

3

Texas Instruments    4Q 2011

LM10504 evaluation software is supplied together with documentation 
regarding the circuit. Copy the folder “lm10504” to your PC’s hard disk. 
The software is run by double clicking the icon of lm10504.exe found in the 
folder. The software does not require any installation. 

The evaluation software allows control of all registers necessary to program 
the device. To simplify the use of software, the registers are set by directly 
named controls. The user does not need the register value as this is taken 
care of by the software. For example, to change LDO3 output voltage to 
1.0V, choose the related value and the software will send the correct value 
to the LDO3 control register

Please use ESD protection when handling the evaluation boards to prevent 
any damage from ESD events!

Connect the LM10504 evaluation board to the USB port of a PC using the 
USB cable.

When the USB board is plugged in for the first time, the operating system 
prompts for  
“New hardware found” and installs the USB driver. If this does not happen, 
try unplugging and plugging the cable in again.

Always disconnect the USB cable from the computer when changing 
jumper settings.

If the evaluation board is not responding or the evaluation software hangs 
up, disconnect the USB cable for 5 seconds.

The graphical user interface has a main screen with two tab screens 
(System and Log) which allow control and indication for different functions 
of the device.

Once the evaluation board is connected to the PC, double click on the GUI 
icon and the device can be controlled via the software interface.