Ea Elektro Automatik EA Elektro-Automatik 06230319, 1 Output Variable DC Power Supply, , Bench 06230319 Hoja De Datos

Page 31

EA Elektro-Automatik GmbH

Helmholtzstr. 31-33 • 41747 Viersen

Germany

Fon: +49 2162 / 3785-0

Fax: +49 2162 / 16230

The USB-B port on the back side of the device is provided for communication with 

the device and for firmware updates. The included USB cable can be used to connect 

the device to a PC (USB 2.0 or 3.0). The driver is delivered on the included CD and 

installs a virtual COM port. Details for remote control can be found on the web site 

of the manufacturer or on the included CD. A general programming introduction for 

the USB port is available (date: 01-12-2015) 
The device can be addressed via this port either using the international standard 

ModBus protocol or by SCPI language. The device recognises the message protocol 

used automatically.
If remote control is in operation the USB port has no priority over either the interface 

module (see below) or the analog interface and can, therefore, only be used alterna-

tively to these. However, monitoring is always available.

This slot on the back side of the device (only with standard models, units with option 

3W installed are different) is available for various modules of the AnyBus CompactCom 

(abbr.: ABCC) type of the IF-AB interface series. The following options are available:

Article number Name

Description

35400100

IF-AB-CANO

CANopen, 1x Sub-D 9pole male

35400101

IF-AB-RS232

RS 232, 1x Sub-D 9pole male (null modem)

35400103

IF-AB-PBUS

Profibus DP-V1 Slave, 1x Sub-D 9pole female

35400104

IF-AB-ETH1P

Ethernet, 1x RJ45

35400105

IF-AB-PNET1P

ProfiNET IO, 1x RJ45

35400106

IF-AB-DNET

Devicenet, 1x Wago plug 5pole

35400107

IF-AB-MBUS1P

ModBus TCP, 1x RJ45

35400108

IF-AB-ETH2P

Ethernet, 2x RJ45

35400109

IF-AB-MBUS2P

ModBus TCP, 2x RJ45

35400110

IF-AB-PNET2P

ProfiNET IO, 2x RJ45

The modules are installed by the user and can be retrofitted without problem. A firmware update of the device may 

be necessary in order to recognize and support certain modules.
If remote control is in operation the interface module has no priority over either the USB port or the analog interface 

and can, therefore, only be used alternately to these. However, monitoring is always available.

This 15 pole Sub-D socket on the back side of the device is provided for remote 

control of the device via analog signals or switching conditions. 
If remote control is in operation this analog interface can only be used alternately to 

the digital interface. However, monitoring is always available. 
The input voltage range of the set values and the output voltage range of the monitor 

values, as well as reference voltage level can be switched  in the settings menu of 

the device between 0-5 V and 0-10 V, in each case for 0-100%.