Ea Elektro Automatik EA Elektro-Automatik 06230319, 1 Output Variable DC Power Supply, , Bench 06230319 Hoja De Datos

Page 83

EA Elektro-Automatik GmbH

Helmholtzstr. 31-33 • 41747 Viersen

Germany

Fon: +49 2162 / 3785-0

Fax: +49 2162 / 16230

The device needs no maintenance. Cleaning may be needed for the internal fans, the frequency of cleanse is 

depending on the ambient conditions. The fans serve to cool the components which are heated by the inherent 

power loss. Heavily dirt filled fans can lead to insufficient airflow and therefore the DC output would switch off too 

early due to overheating or possibly lead to defects.
Cleaning the internal fans can be performed with a vacuum cleaner or similar. For this the device needs to be opened.

If the equipment suddenly performs in an unexpected way, which indicates a fault, or it has an obvious defect, this 

can not and must not be repaired by the user. Contact the supplier in case of suspicion and elicit the steps to be 

taken.
It will then usually be necessary to return the device to the supplier (with or without guarantee). If a return for 

checking or repair is to be carried out, ensure that:
•

the supplier has been contacted and it is clarified how and where the equipment should be sent.

•

the device is in fully assembled state and in suitable transport packaging, ideally the original packaging.

•

optional extras such as an AnyBus interface module is included if this is in any way connected to the problem.

•

a fault description in as much detail as possible is attached.

•

if shipping destination is abroad, the necessary customs papers are attached.

The device is protected one 5x20 mm fuse (T16 A, 250 V) which is located on the rear of the device, inside a fuse 

holder. To replace the fuse, the device is not required to be opened. Just remove the power cord and unscrew the 

fuse holder with a flat screw driver. The replacement fuse must be of same value and type.