Ea Elektro Automatik EA Elektro-Automatik 06230319, 1 Output Variable DC Power Supply, , Bench 06230319 Hoja De Datos

Page 6

EA Elektro-Automatik GmbH

Helmholtzstr. 31-33 • 41747 Viersen

Germany

Fon: +49 2162 / 3785-0

Fax: +49 2162 / 16230

A piece of equipment which is intended for disposal must, according to European laws and regulations (ElektroG, 

WEEE) be returned to the manufacturer for scrapping, unless the person operating the piece of equipment or an-

other, delegated person is conducting the disposal. Our equipment falls under these regulations and is accordingly 

marked with the following symbol:

Decoding of the product description on the label, using an example:

Field for identification of installed options and/or special models
S01...S0x = Special version
HS = High Speed option installed
3W = Option 3W installed (GPIB port instead of Anybus slot)
Construction (not always given)
2U / 3U / 4U = 19" frame with 2U, 3U or 4U
T = "Tower" - vertical standing model
DT = "Desktop" model
R = "Rack mount" model in frame for wall mounting
Maximum current of the device in Ampere
Maximum voltage of the device in Volt
Series : 

8 = Series 8000 or 800, 9 = Series 9000

Type identification:
PS = Power Supply, usually programmable
PSI = Power Supply Intelligent, always programmable
ELR = Electronic Load with Recovery 

The equipment is intended to be used, if a power supply or battery charger, only as a variable voltage and current 

source, or, if an electronic load, only as a variable current sink.
Typical application for a power supply is DC supply to any relevant user, for a battery charger the charging of vari-

ous battery types and for electronic loads the replacement of an ohmic resistor by an adjustable DC current sink 

in order to load relevant voltage and current sources of any type.

•

Claims of any sort due to damage caused by non-intended usage will not be accepted.

•

All damage caused by non-intended usage is solely the responsibility of the operator.