Brennenstuhl 1172620 Hoja De Datos

19

Disconnect the wire. For this purpose, detach the pull relief and press the wire button to the 
wire block. 

  8 

Wiring 

19 Pull 

relief 

20 Wire 

button 

21 Wire 

block

4

Detach the bush by rotating in the anti-clockwise pattern. 

13 Casing 

14 

Bush including bending protection 

5

6 

Unscrew the old wiring. 

7

 WARNING: Use only original accessory of the same type during replacing the wiring 

and the same wiring length. 

IMPORTANT: The green / yellow earthing wire must always be 3 cm longer than both 

the other wiring. 

Retract the wiring. 

8 

Clamp the wiring in the wire block. For this purpose, press the wire button and push the 
wiring in the wire block. 

9 

Bolt the bush. 

10 

Position the metal plate. Fasten the metal plate with the previously removed bolts. 

11 

Fit the reflector in the casing. Fasten it with the reflector bolts. 

12 

Mount the illuminant (See chapter replace illuminant step 4+5) 

IMPORTANT: Check all the bolted connections before the initial operation. 

Pull the main plug before cleaning. Due to reasons of the electrical security, the device is to be cleaned 
with a dry or damp cloth. Please do not use any sharp cleaning material or chemicals (solvents, petrol 
etc) and no rough sponges. Never dip the working lamp in water. 

The product should not be disposed in normal domestic waste at the end of its lifetime. Please enquire 
with your city or municipal administration on possibilities of environmentally compatible and appropriate 
disposal of the device. 

8

19

20

21

13

14