Medisana BU575 Blood Pressure Monitor 51296 Manual De Usuario

Press M-button       to enter the memory recall mode.                                                 

 i

If you only want to delete the last measured value, press and hold the SET / SNOOZE - 
button       for approx. 7 seconds. The last measured value will flash two times and will 
then be deleted. The display shows "dEL". Press START/STOP            , to exit the de-
lete mode. If you want to delete all stored values in memory for a user, press and hold 
M-button       AND 

       simultaneously for approx. 10 seconds. 

SET / SNOOZE - button

The display shows "dEL ALL". Now press the 

       to confirm 

SET / SNOOZE - button

the deletion. The display shows "dEL OK" - now all stored values for this user are de-
leted and the unit will switch off automatically. If you want to abort the deletion process, 
press START/STOP          while the display shows "dEL ALL". The unit then switches 
itself off without deleting any value.















Low battery 

Bluetooth transfer of
data not possible

Cuff not properly
fitted

Cuff too tight

Failure during
inflation

Movement or speaking 
during measurement or 
pulse too weak

Pulse cannot be
detected

Measurement failed

Calibration error

The built-in battery is too low or empty.
Charge the battery.

Check the software and if Bluetooth is properly 
configured and activated on the receiving units.

Wrap the cuff properly. Remeasure in correct 
way.

Wrap the cuff properly. Remeasure in correct 
way.

Wrap the cuff properly. Check, if the air hose
is properly connected to the unit. Remeasure
in correct way.

remeasure in correct 

Rest 30 minutes and 
way. Do not speak or move during the
measurement.

Wrap the cuff properly. Remeasure in correct 
way.

Rest 30 minutes and remeasure in correct 
way.

Wrap the cuff properly. Remeasure in correct 
way.