Atmel ATSTK500 500 Starter kit and development system. ATSTK500 ATSTK500 Hoja De Datos

 

2591C-AVR-06/06 

Uploads the control stack to the STK.  This is used for both PP and HVSP. 

Note: 

The Control stack must always be uploaded before performing any programming 
commands in high voltage mode if the STK500 has been powered down. 

 

To check if the controller has a valid control stack: Read 
PARAM_CONTROLLER_INIT 

Se chapter 5.7.14:  PARAM_CONTROLLER_INIT 

Table 5-52. Command format 

Command ID 

1 byte 

CMD_SET_CONTROL_
STACK 

Command id 

Data 

32 bytes 

 

Control stack Data 

 

Table 5-53. Answer format (same for all results) 

Answer ID 

1 byte 

CMD_SET_CONTROL_
STACK 

Answer id 

Status 1 

byte 

STATUS_CMD_OK 

A Result Value indicating the result 
of the operation 

This chapter describes the High Voltage Serial Programming (HVSP) commands. 
Note that the SetControlStack command is required for HVSP as for PP. Description 
of the SetControlStack is found in section 5.3.14 under Parallel Programming. 

This command will make the target device enter programming mode if it succeeds. 

XML path: /AVRPART/ICE_SETTINGS/STK500_2/HvspEnterProgMode/