Blade BLH3450 Hoja De Datos

8

EN

Place the helicopter outdoors on a clean, fl at and level 
surface (concrete or asphalt) free of obstructions. Always 
stay clear of moving rotor blades. 

1.  The motor beeps twice when the helicopter’s ESC 

arms properly. Before you continue, confi rm that
TH HOLD is ON. 

WARNING: The motor will spin when throttle is 
increased while TH HOLD is OFF.

2.  Check the swashplate directions to ensure they are 

moving in the correct direction.  Please refer to the 
diagrams above for reference.

WARNING: Stay at least 30 feet (10 meters) 
away from the helicopter when the motor is 

running. Do not attempt to fl y the helicopter at this time.

3.  Ensure the throttle is lowered completely. Turn throttle 

hold off at this time and confi rm the transmitter is still 
set to normal fl ight mode. Slowly increase the throttle 
until the blades begin to spin.  The main blades spin 
clockwise when viewing the helicopter from the top. 
The tail rotor blades spin counterclockwise when 
viewing the helicopter from the right-hand side.

NOTICE: If the main rotor blades are spinning coun-
terclockwise, reduce the throttle to low immediately. 
Turn throttle hold on. Disconnect the battery from the 
helicopter and reverse any two motor wire connections 
to the ESC and repeat the motor control test.