Blade mCP X BL BNF BLH3980 Hoja De Datos

®

To bind or re-bind your mCP X BL to your chosen transmitter, please follow the directions below:

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) 
code of a single specifi c transmitter. You need to ‘bind’ your chosen Spektrum

 

DSM2 /

 

technology equipped aircraft transmitter to the receiver for proper operation. 

9

1. Disconnect the fl ight battery from the helicopter.

2. Power off the transmitter and move all switches to the 0 position.

3. Connect the fl ight battery to the helicopter. The 3-in-1 Control unit LED fl ashes after 5 seconds.

4.  Push in on the bind switch/button while powering on the transmitter.

5.  After 2–3 seconds, release the bind switch/button.

6. Disconnect the fl ight battery and power the transmitter off.

The throttle will not arm if the transmitter’s throttle control is not put at the lowest position and the stunt mode 
switch is not in the 0 position.

If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other 
instructions.  If needed, contact the appropriate Horizon Product Support offi ce. 

For a list of compatible DSM

®

 transmitters, please visit www.bindnfl y.com.

Model Type
HELI

Swash Type
1 Servo Normal

F-Mode Setup
Flight Mode: F Mode
Hold: Hold

Frame Rate
22 ms
DSMX

0-AILE  

70%  40%

0-ELEV  

70%  40%

0-RUDD 100% 

0%

1-AILE  

100%  40%

1-ELEV  

100%  40%

1-RUDD 100% 

0%

2-AILE  

100%  40%

2-ELEV  

100%  40%

2-RUDD  

100%  0%

Throttle Curve
NORM 

 

0%  40% 60% 80% 100%

ST-1  

100% 

90% 80% 90% 100%

ST-2   

100% 100% 100% 100% 100%

HOLD 

 

0% 0% 0% 0% 0%

Pitch Curve
NOR  

30% 40% 50% 75% 100%

ST-1  

0%  25% 50% 75% 100%

ST-2  

0%  25% 50% 75% 100%

HOLD  

0%  25% 50% 75% 100% 

Reverse
THRO - N
AILE - N 
ELEV - N
RUDD - N
GEAR - N
PIT. - N

Timer
MODE Countdown
TIME  4:00 Tone/Vibe (Basic Flying)
 

3:00 Tone/Vibe (Advanced Flying)

START Throttle Out
POS 25

SERVO SETUP
Travel
THRO 100%
AILE 100%
ELEV 100%
RUDD 100%
GEAR 100%
PIT. 100%

1.  Lower the throttle and throttle trim to the lowest 

settings.

2. Power on the transmitter.

3.  Install the fl ight battery in the battery holder. Con-

nect the battery cable to the 3-in-1 control unit.

NOTICE: Do not allow the helicopter to move until the 
blue LED on the 3-in-1 control unit is solid.

NOTICE: Always disconnect the Li-Po battery from 
the 3-in-1 control unit of the aircraft when not fl ying. 
Batteries discharged to a voltage lower than the lowest 
approved voltage may become damaged,resulting in loss 
of performance and potential fi re when batteries are charged.