DeLonghi DMX 664 V Hoja De Datos
14
DEScRIPTIon oF THE APPLIAncE
(see page 3)
A Water tank door
B Hook for steam/cable tube and protective
A Water tank door
B Hook for steam/cable tube and protective
cap for limescale prevention system
c Iron rest
D Cable tidy
control panel
E “Steam ready” light
F Iron on button
G Iron on light
H Steam regulation knob
I Steam generator on light
J Steam generator on button
K “No water” light
“Professional” iron
L Steam button
M Continuous steam lock
n Thermostat knob
o Iron at temperature light
“Domestic” iron
L Steam button
M Continuous steam lock
n Thermostat knob
o Iron at temperature light
P (Some models only) Iron release button (for
D Cable tidy
control panel
E “Steam ready” light
F Iron on button
G Iron on light
H Steam regulation knob
I Steam generator on light
J Steam generator on button
K “No water” light
“Professional” iron
L Steam button
M Continuous steam lock
n Thermostat knob
o Iron at temperature light
“Domestic” iron
L Steam button
M Continuous steam lock
n Thermostat knob
o Iron at temperature light
P (Some models only) Iron release button (for
safe transport)
PREPARATIonS FoR USE
What water to use
The appliance works with normal tap water� In
case of very hard water (hardness above 27°F)
we suggest using demineralised water diluted
with 50% tap water.
Never use demineralised water on its own.
Never use chemical substances or detergents
(e.g. perfumed water, essences, descaling solu-
tion, etc).
Important!
Never use other types of water, chemical sub-
stances or detergents (e.g. perfumed water, es-
sences, water softener, etc).
Filling the tank
Danger!
Make sure the cable is unplugged from the
mains socket.
• Open the door of the water tank and fill. Ne-
ver exceed the MAX level marked on the tank
(0.7 l).
• Plug the appliance into a mains socket.
Please note:
The first time you use the appliance, the steam
generator is empty.
When filling the steam generator for the first
time, the heating up time will be longer as the
air must be eliminated from the steam generator
and replaced by the water.
During filling/heating it is normal for the pump
to make a noise.
The appliance will also run out of water much
more quickly than with subsequent fills.
oPERATIon
Steam ironing
• Press the
• Press the
(iron on) button F and the
(steam generator on) button J. The
lights on the corresponding buttons come
on.
• Wait for the
(steam ready) light E to
come on and the light o to go off.
• Proceed by pressing the steam button L.
Please note:
• When used for the first time, the appliance
may give off smoke and an odour for several
minutes. This is caused by heating and sub-
sequent drying of the sealers used in assem-
bling the steam generator and iron.
You are recommended to ventilate the
room.
• Lights E and o will go on and off during iro-
ning, according to the temperature reached
by the steam generator and iron.
It is part of normal operation and not a cause
for concern.
• While ironing, it is normal to hear the water
fill pump come on and go off.
This is caused by transfer of water from the
tank to the steam generator.
This is part of normal operation and is not a
cause for concern.