DeLonghi DMX 664 V Scheda Tecnica

14

(see page 3)
A   Water tank door
B   Hook  for  steam/cable  tube  and  protective

cap for limescale prevention system

c    Iron rest
D   Cable tidy
control panel
E   “Steam ready” light
F   Iron on button
G   Iron on light
H   Steam regulation knob
I   Steam generator on light
J   Steam generator on button
K   “No water” light
“Professional” iron
L   Steam button
M   Continuous steam lock 
n   Thermostat knob
o   Iron at temperature light
“Domestic” iron
L   Steam button
M   Continuous steam lock 
n   Thermostat knob
o   Iron at temperature light
P   (Some models only) Iron release button (for

safe transport)

The appliance works with normal tap water� In

case of very hard water (hardness above 27°F)

we  suggest  using  demineralised  water  diluted 

with 50% tap water. 

Never use demineralised water on its own.

Never  use  chemical  substances  or  detergents

(e.g. perfumed water, essences, descaling solu-

tion, etc).

Never  use  other  types  of  water,  chemical  sub-

stances or detergents (e.g. perfumed water, es-

sences, water softener, etc).

Make  sure  the  cable  is  unplugged  from  the

mains socket.

•  Open the door of the water tank and fill. Ne-

ver exceed the MAX level marked on the tank

(0.7 l).

•  Plug the appliance into a mains socket.

The first time you use the appliance, the steam

generator is empty.  

When  filling  the  steam  generator  for  the  first

time, the heating up time will be longer as the

air must be eliminated from the steam generator

and replaced by the water.

During filling/heating it is normal for the pump

to make a noise.  

The  appliance  will  also  run  out  of  water  much 

more quickly than with subsequent fills.

Steam ironing
•  Press  the  

 (iron  on)  button  F  and  the  

 (steam  generator  on)  button  J.  The 

lights  on  the  corresponding  buttons  come

on. 

•  Wait  for  the   

  (steam  ready)  light  E  to 

come on and the light o to go off. 

•  Proceed by pressing the steam button L. 

•  When used for the first time, the appliance

may give off smoke and an odour for several

minutes. This is caused by heating and sub-

sequent drying of the sealers used in assem-

bling the steam generator and iron.

You  are  recommended  to  ventilate  the

room.

•  Lights E and o will go on and off during iro-

ning, according to the temperature reached

by the steam generator and iron.

It is part of normal operation and not a cause

for concern.

•  While ironing, it is normal to hear the water

fill pump come on and go off.

This is caused by transfer of water from the

tank to the steam generator. 

 

This is part of normal operation and is not a 

cause for concern.