C Control PRO-BOT128 + C-Control PRO 128 Unit + Voltcraft® USB programming cable Kit 190406 Manual De Usuario

The LEDs are not lit:
• LEDs installed in the right direction?
• Proper protective resistor installed?
• Cold soldering spot?
• Does the C-Control PRO work?
• Right program installed?
• Batteries/rechargeable batteries empty?

Beeper does not work:
• Installed in the right direction?
• Cold soldering spot?
• Right program in C-Control?
• C-Control PRO ok?
• Batteries/rechargeable batteries empty?
• Proper protective resistor installed?

Sound level sensor does not work:
• IC LM386 plugged in correctly?
• Microphone soldering in the proper direction?
• Properly equipped?
• Right program installed?
• Batteries/rechargeable batteries empty?
• Cold soldering spots?
• Capacitor C7 defect?

ACS does not work properly or not at all:
• IR LEDs installed in the right direction?
• Right program in C-Control PRO?
• Attempts to change the PWM? (See program code)
• Shrinkdown plastic tubing installed properly on the IR diodes?
• Change obstacles if necessary (IR has problems with black)
• C-Control PRO ok?
• Batteries/rechargeable batteries empty?
• Cold soldering spot?

C-Control cannot be connected to IDE:
• Right interface (COM-Port) selected?
• Programming cable installed correctly? (See device manager)
• Programming cable correctly attached to the plug?
• Does the programming cable function? (poss. bridging RX and TX and intercepting the echo via a terminal program)
• Is the C-Control PRO in boot mode? (Press reset and boot -> let go of reset and then of the boot key)
• Is the C-Control positioned correctly in the mount?
• Soldering error?
• Batteries/rechargeable batteries empty?