Schlegel S_789-602 4-channel Radio Receiver With 4 Changeover Contacts 4-channel-radio receiver S_789-602 Manual De Usuario
Los códigos de productos
S_789-602
Mounting - and Installation Instructions 789-601 / 789-602 incl. Versions /xxx- xxx
WAGO Kontakttechnik GmbH & Co. KG, D-32423 Minden, Hansastraße 27 •www.wago.com
9970-0966/0789-0601/08-07_SW03
9. Technical Data
9.1 Max. permissible Load acc. to EN60669-2-1
9.2 Max. DC Load Breaking Capacity
DC breaking capacity
of 789-601
of 789-601
DC breaking capacity
of 789-602
Des ign ation
Item-no.
789-601
789-602
Supply voltage
Current consumtion (internal)
No. of channels / outputs
No. Of receive-channels
Max sw itching f requency.
Delay-time ( Transmitter /
Delay-time ( Transmitter /
ouput command)
Type of contacts
NO contac ts
CO contacts
Sw itching voltage
Fusing of Loads
Output current (per Channel)
max. 16A, A C1
max. 8A , A C1
Type of load
Potential bonding
Potential bonding
Supply / Atenna
Supply / Contac ts
Channel / Channel
Open Contacts
Open Contacts
A mbient temperature
Storage temperature
Relative humidity
Degree of pollution
Degree of protection
Mounting position
Terminals
Stripping length
Housing
Mounting
Dimensions (w x h x d)
A pprovals
40 / 10 per output
Modular Installation Housing
5 Hz
< 100ms
typ. 40...70ms
Wire breaker; max . 16A
DIN Rail acc. EN 50022
230V ~
KEMA; acc. EN 60669-2-1:1996
2
IP20
-
4 kV ef f .
2,2 kV ef f .
1 kV ef f .
0 ... +55°C
appr. 70 x 90 x 55 mm
Data
5 - 6 mm
optional
WAGO CA GE-CLA MP (R) Series 236
-25 ... + 85°C
85% w ithout condensation
see table 8.1
DC24V –15/+20%
Max. 90mA
4
9.3 Data Processing of PTM / STM Data
The Radio Receiver is analyzing binary data from different
types of radio transmitters which are based on the EnOcean
Radio Techno-logy. From following type of modules data could
be processed:
Module type EnOcean
The Radio Receiver is analyzing binary data from different
types of radio transmitters which are based on the EnOcean
Radio Techno-logy. From following type of modules data could
be processed:
Module type EnOcean
Application
PTM 100, 200, 230
push-buttons
STM250
window-contacts
STM100
industrial sensors / switches
From the data telegrams the following bits are used:
10. Accessories
Antenna: WAGO 758-910 incl. 2.5 m RG174-cable and SMA-
Connector.
Antenna: WAGO 758-910 incl. 2.5 m RG174-cable and SMA-
Connector.
11. General Advices for EnOcean Radio Technology
11.1 Safety Advices conc. R&TTE: Danger
The radio receiver modules must not be used in any
relation with equipment that supports, directly or
indirectly, human health or life or with applications
that can result in danger for people, animals or real
value.
relation with equipment that supports, directly or
indirectly, human health or life or with applications
that can result in danger for people, animals or real
value.
This results from the classification of the radio receiver module
in “Class 2 Equipment”according to ETSI EN 301 489-3 V1.4.1
(2202-08) "Specific conditions for short-range devices (SRD)".
in “Class 2 Equipment”according to ETSI EN 301 489-3 V1.4.1
(2202-08) "Specific conditions for short-range devices (SRD)".
11.2 Details for Transmission Range
The transmission ranges are mainly depending on mounting
and positioning as well as type of material which is used in
buildings. The type of used materials and thickness of walls
have a main influence to the quality and the strength of radio
data.
It is recommended to make tests of data transmission at
desired mounting positions before installation.
The transmission ranges are mainly depending on mounting
and positioning as well as type of material which is used in
buildings. The type of used materials and thickness of walls
have a main influence to the quality and the strength of radio
data.
It is recommended to make tests of data transmission at
desired mounting positions before installation.
11.3 Typical max. Transmission Ranges
1) Visual contacts: typ. 30 m in passages, up to 100 m in halls
2) Rigypsum walls/ wood: typ. 30 m range through max. 5 walls
3) Brick wall /Gas concrete: typ. 20 m range through max. 3
walls
4) reinforceds concrete /-ceiling: typ. 10 m range through max. 1
wall
Supply blocks and lift shafts should be seen as a
compartmentalisation.
1) Visual contacts: typ. 30 m in passages, up to 100 m in halls
2) Rigypsum walls/ wood: typ. 30 m range through max. 5 walls
3) Brick wall /Gas concrete: typ. 20 m range through max. 3
walls
4) reinforceds concrete /-ceiling: typ. 10 m range through max. 1
wall
Supply blocks and lift shafts should be seen as a
compartmentalisation.
11.4 Reduction of Transmission Range
Restriction of the transmission range can also be due to:
•Hollow lightweight walls with insulating wool on metal foil
•suspend ceilings with panels made of metal
•carbon fiber, lead glass or glass with metal coating, metal
furniture
furniture
•metal wall mounting of the switch.
In addition, the angle with which the signal arrives at the wall is
of great importance. Depending on the angle, the effective wall
strength and thus the damping attenuation of the signal
changes. If possible, the signals should run vertically through
the walling. Walling recesses should be avoided.
of great importance. Depending on the angle, the effective wall
strength and thus the damping attenuation of the signal
changes. If possible, the signals should run vertically through
the walling. Walling recesses should be avoided.
For mounting and installation of transmitters please
observe additionally the advices provided by the
manufacturer!
observe additionally the advices provided by the
manufacturer!
Des.
Org-
Data-
EnOcean Byte Typ Byte Bit
PTM100
PTM100
5
RPS
3
4...7
PTM200
5
RPS
3
4...7
PTM230
5
RPS
3
4...7
STM100
7
4BS
0
0
STM250
6
1BS
3
0
Type of load
789-601
789-602
halogen lamps
1400W
1400W
incandescent lamps
2200W
1840W
iron-core transformer
120VA
120VA
fluorescent lamps
4AX
-
capazitive loads
60µF
-
motorload
2A
2A
Product Type
Page 3