Gossen Thermometer 15122 Manual De Usuario
GOSSEN Foto- und Lichtmeßtechnik
4
1
The functioning of the Digisix
1.1 Preparation and self-test
Battery
The Digisix is powered by a 3 V
Lithium battery, type CR 2032.
When the battery is running low, the signal
BAT appears in the display.
– The battery should be replaced as soon
Battery
The Digisix is powered by a 3 V
Lithium battery, type CR 2032.
When the battery is running low, the signal
BAT appears in the display.
– The battery should be replaced as soon
as possible. When BAT is shown alone
in the display, the battery will need to be
replaced before further measurements
are possible.
in the display, the battery will need to be
replaced before further measurements
are possible.
– To replace the battery, pull out the battery
compartment placed under the eyelet for
the carrying cord.
the carrying cord.
– Remove the old battery and insert the
new one. Observe the "+" and "–"
polarity!
polarity!
– Close the battery compartment
Attention! Changing the battery will cancel
all the individual values stored in memory.
Attention! Changing the battery will cancel
all the individual values stored in memory.
Self-Test
After the new battery has been inserted,
the microcomputer will carry out a self-test.
Every display segment appears in the
display panel.
The self-test takes 10 seconds. It can be
interrupted before by pressing any button.
After the new battery has been inserted,
the microcomputer will carry out a self-test.
Every display segment appears in the
display panel.
The self-test takes 10 seconds. It can be
interrupted before by pressing any button.
After the self-test, the standard settings will
be shown as set by the factory.
Standard settings
ISO
be shown as set by the factory.
Standard settings
ISO
100/21°
COR
0
EV
8