Brocade Communications Systems Switch 53-1001762-01 Manual De Usuario

Chapter

7

Layer 2 System Commands

mac-address-table

Use this command to set the aging time or to add static addresses to the MAC address table.

Synopsis

mac-address-table {aging-time seconds| static mac-addr forward [port-channel number | 
tengigabitethernet slot/port | vlan vlan_id] }

no mac-address-table {aging-time | static mac-addr forward [ port-channel number | 
tengigabitethernet slot/port | vlan vlan_id] }

Operands

aging-time seconds

Specifies the time in seconds that a learned MAC address will persist after 
the last update. If the aging time is set to zero (0), it means that aging is 
disabled. The range of valid values is 10-100000.

static mac-addr

Specifies the Media Access Control (MAC) address (unicast or multicast) to 
add to the address table. Packets with this destination address received in 
the specified VLAN are forwarded to the specified interface.

forward

Forwards the MAC address to the interface.

port-channel number

Specifies the port-channel number. The range of valid values is 1–63.

tengigabitethernet

Specifies a valid 10 Gbps Ethernet interface.

Specifies a valid slot number.

Specifies a valid port number.

vlan vlan_id

Specifies the VLAN number. The range of valid values is 1-3583.

Defaults

The default aging time is 300 seconds.

Command

Modes

Global configuration mode

Description

Use this command to set the aging time or to add static addresses to the MAC address table.

Usage

Guidelines

The vlan keyword is mandatory because the switch only supports independent VLAN learning (IVL).

Examples

To add the static address 0011.2222.3333 to the MAC address table with a packet received on 
VLAN 100:

switch(config)#mac-address-table static 0011.2222.3333 forward 

tengigabitethernet 0/1 vlan 100