Bunn G9-2T HD DBC Manual De Propietario

6

33736  072310

WARNING - Unplug the grinder before the removal of any panel or grind chamber-housing parts.

1.  Clean all exterior surfaces using a damp cloth rinsed in any mild, nonabrasive, liquid detergent. Care should 

be taken not to scratch the grinder with any abrasive material.

2.  Empty all beans from hopper(s). Plug in the grinder; place an empty funnel with filter into the funnel rails. 

Press and release the “GRIND” button. Run a few cycles until all coffee in the grind chamber is dispensed 

and disconnect the grinder from the power source. 

3.  Remove the upper front inspection panel.

4.  Remove the two screws holding the front cover to the burr housing. Carefully remove the burr housing front 

cover. Clean inside surface with a dry stiff non-metallic bristle brush and wipe with a dry clean cloth.

5.  Carefully remove the rotor cup, shear plate burr rotor and motor shaft extension from the grinder. Clean all 

parts with a dry stiff non-metallic bristle brush and wipe with a dry clean cloth.

6.  Clean the grind chamber with a dry stiff non-metallic bristle brush and wipe with a dry clean cloth.

7.  Reinstall the motor shaft extension, burr rotor, shear plate, rotor cup and front cover to the burr housing.

8.  Reinstall the upper front inspection panel,

9.  Refer to the “Adjustment” section of the Operating and Service manual for burr adjustments.

 

1.  Visually inspect the selected hopper for an ample supply of whole bean coffee.

2.  Place a paper filter into the brew funnel. The filter must not be folded-over or tilted to one side.

3.  Insert the funnel into the funnel rails and push until it stops.

4.  Choose the batch size and side of grinder to use.

5.  Press the GRIND button. The grinding action will stop automatically after the preset amount of ground coffee 

is dispensed into the funnel.

Bunn-O-Matic

®

 Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance 

should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic

®

 Corporation at 

1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.

6-Month 

Weekly Cleaning plus replace the dechaffer assembly.

 

05995.1000  Dechaffer Plate (package of 6)

1.  On grinders with slide plates check the slide plates and clean. 

2.  Inspect and clean/replace burrs and grind chamber if necessary.

3.  Adjust the burrs and grind time to your specifications for particulate size and throw weight.