Bunn Beverage Dispenser FMD-5 Manual De Usuario

16

FIG. 5 AUGER DRIVE & HOPPER DISASSEMBLY

1.   Hopper Lid

2.   Mixing Blade

3.  Agitator Disk

4.  Auger Drive Shaft   

 Bushing

5.  Auger Drive Shaft 

6.   Locknut

7.   Auger Drive Bracket

8.   Hopper

9.  Auger Wire

10. Ejector Elbow

11. Hopper Assy

12. Auger Motor Mounting  

 Panel

13. Hopper Support Plate

14. Auger Motor Bracket

15. Auger Motor

16. Dust Seal

P2634

1

2

3

8

7

6

4

5

9

10

14 15 16 12 13

11

Removal, Cleaning and Replacement
Hopper & Auger (all other hoppers)

1.  Open the dispenser door and raise the top front 

cover.

2.  Lift the front edge of hopper assy (20) over the 

tab on hopper support plate (19) and slide hopper 

assembly out the front of the dispenser.

3.  Remove hopper lid (1) and empty product.

4.  Pull off the ejector elbow (13).

5.  Remove agitator disc assy (2) by pulling agitator 

support rod (4) towards agitator disc assy and 

lifting agitator disc assy from hopper (10).

6.  Remove auger (12) by pulling it out the front of 

the hopper (10).

7.  Remove auger drive shaft (5) by removing the 

retaining clip (6) from auger drive shaft. 

8.  Slide washer (8) and auger drive shaft bracket (7) 

off of the auger drive shaft (5).

9.  Slide auger drive shaft (5) from auger drive shaft 

bushing (3) and remove from hopper (10).

10.  Remove locknut (9) from auger drive shaft bushing 

(3) and remove auger drive shaft bushing from 

hopper (10).

11.  Wash components in a mild solution of dish de-

tergent using a bristle brush when needed.

12.  Rinse and dry each item thoroughly.

13.  Check for damaged or broken components, replace 

any if necessary and reassemble hopper assy.

14. Install hopper assy (20) in  the dispenser by sliding 

hopper assy in the guides  on the hopper support 

plate (19) until the slot in the bottom rear the hop-

per seats against the pin (18) in the hopper support 

plate.

42672 122209