Bunn Beverage Dispenser CDS-3 Manual De Usuario

35

The “A” shaped Cooling Drum Shipping Supports, 

removed during Initial Set-Up should be kept and used 

as a tool to reset the alignment of the cooling drums 

should it ever be required.
Symptoms:

Squeaky Operation, hopper lifts or won’t seat properly, 

hopper is pushed to one side or the other.
To check alignment

1.  Place the “A” shaped support on the auger shaft 

with the ledge under the cooling drum.

2.  Lift the cooling drum while rotating the support into 

a vertical position. The boss on the very bottom 

will drop into the hopper drip tray’s drain hole.

Ledge

Boss

Legs

When  in  its  proper  position,  the  cooling  drum  will 

cause a slight pressure on the hopper drip tray drain 

hole  and  the  two  legs  will  be  equidistant  from  the 

hopper drip tray.
If adjustment is needed, remove the support and gently 

force the free end of the evaporator in the direction 

the adjustment is needed.
Reinstall the support, check the alignment, and read-

just the cooling drums as required.  

P1510

FIG. 23 COOLING DRUM SHIPPING SUPPORT

FIG. 24 CHECKING ALIGNMENT

27646 122200