Bunn Beverage Dispenser CDS-3 Manual De Usuario

6

6.0"

MIN.

6.0"

MIN.

6.0"

MIN.

CAUTION – The dispenser is very heavy! Use care when lifting or moving it. Use at least two people to lift or 

move the dispenser.

1.  Set the dispenser on the counter where it will be used. The CDS-3 dispenser requires a minimum of 6.0” 

air clearance on both sides and at the rear of the dispenser. For optimum performance, do not let warm air 

from surrounding machines blow on the CDS-3 and DO NOT REMOVE VINYL DEFLECTOR. 

NOTE – The dispenser should be level or slightly lower in front for proper operation.

Vinyl Deflector

6.  Press  the  seals  firmly  into 

place.

7.  Apply a thin film of lubricant to 

the inside of each auger shaft 

seal.

8.  Install  the  seals  on  the  auger 

shafts. Wipe the cooling drums 

to remove any lubricant.

3.  Squeeze  some  lubricant  into 

hand. 

4.  Apply a thin film of lubricant to 

each cooling drum seal.

5.  Install the seal over the flange 

at the rear of each cooling drum 

as shown.

2.  Remove all shipping material, including the compressor support eye-bolts, the cooling drum supports, the 

“Do Not Lift Here” signs from the cooling drums, and the “Rinse Before Using” signs from each hopper.

NOTE – Use BOM M2550.0000 lubricant where specified.

27646 022500