Bunn trifecta Manual De Propietario

Page 12

Remove drip tray. Remove two screws. 

Lower the panel as far as it will go.

Push the top down to clear the brew cham-

ber support arm, then pull the top out first.

Pull drain hose out as shown. Slide clamp 

back and remove plug. Refer to program-

ming section and enter "Factory Blowout" 

mode. Allow tank to drain into sink or 

suitable container.

Disconnect brewer from power source. Connect to 

water supply. Install brew cup & chamber. Push and 

hold both arrow buttons while plugging in the brewer. 

When display reads "SET TO FIRST TIME UP", release 

arrow buttons. Place a minimum 40 oz. container under 

brew chamber. Press brew start button to begin cycle. 

If tank was empty, it will  expel only 20 oz. If tank was 

still full, it will expel 40 oz.

42822.1 040810

WARNING