Harbor Freight Tools 7 in. 1.5 HP Bridge Wet Cut Tile Saw with Stand Manual Del Producto
Page 12
For technical questions, please call 1-800-444-3353.
Item 60608
SAFETY
OPERA
TION
MAINTENANCE
SETUP
Miter Adjustment
1. Loosen the T-Knob (103A) on the Miter Gauge
(102) and position the Miter Gauge at the
desired angle. Retighten the T-Knob.
2. To adjust the gap between the Miter Gauge
(102) and the cutting slot in the Table, loosen
the T-Knob (103B) on the Miter Gauge
Guide (105). Move the Miter Gauge to the
desired position. Retighten the T-Knob.
T-Knob (103B)
Miter Gauge
Guide (105)
Miter Gauge
(102)
T-Knob
(103A)
Table
Cutting Slot
Figure 14: Miter Adjustment
Bevel Adjustment
1. Loosen the Locking Knobs (75) on each
end of the Tile Saw. Also loosen two Bolts
(73) located on the lower ends of the Right
and Left Guide Rail Stands (72, 111).
Locking
Knob (75)
Figure 15: Right End of Tile Saw
Right Guide
Rail Stand
(111)
Right Side
Angle Scale
(110)
Bolt (73)
2. Tilt the Guide Rail Stands to the desired
angle (0 to 45°) as indicated on the Right and
Left Side Angle Scales (74, 110). Retighten
the two Locking Knobs and two Bolts.
Figure 16: Left End of Tile Saw
Left Guide
Rail Stand
(72)
Left Side
Angle Scale
(74)
Bolt (73)
Locking
Knob (75)
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
Set up the Power Cord with a drip loop —
see POSITION OF TILE SAW on page 5.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
4. Keep workpieces pressed firmly against the
Table and Scale Plates while cutting.
5. Mark cut lines using waterproof marker or crayon.