Emerson Liebert iCOM Manual De Usuario

S435 Measure Type—Determines the measurement units and range for each analog input.

Factory Std measurement type means the input is being used by the factory-configured device 

for unit control and cannot be set to any other measurement type. 
Not Config measurement type means the input is available for custom sensor use, but has not 

been configured. After unit code execution, all analog inputs that are available will be set to “Not 

Config,” and can then be set to any of the following choices by the user:

• Air Pres 1, 2, 3 or 4
• Pressure 1, 2, 3 or 4
• Temp 1, 2, 3 or 4
• Percent 1, 2, 3 or 4

It is not necessary to match a measurement type number to the analog input number (i.e., “Air 

Pres 2” does not have to be connected to Analog Input 2). The numeric designation on each 

measurement type is just to allow the user to differentiate between readouts if multiple 

measurements of the same type are required.

Precision—Parameters in the Precision column must match the DIP switch settings for each analog 

input being used. There are two choices for these parameters: 0-5V and 0-10V. This setting will also 

regulate the range of an analog input’s linear characteristic on Page 5 of the Options Setup screen of 

the Service Menu (see Figure 171). 
S441 Units system for Custom Inputs—Determines the unit type (English or SI) that will be used 

for the setup and readout of custom sensors. This parameter affects only analog inputs. All lines in 

other menus involving pressures or temperatures will have their readout type determined by line 

U404 of the User - Selection menu. The table below shows the English and SI units for each 

measurement type.

When the unit type is changed on line S441, the linear characteristics for all of the inputs on Page 5 of 

the Options Setup screen of the Service Menu will be converted to match the new units system, and 

the readout in the Sensor Data in the User Menu will also change to reflect the new units.

Air Pres

inWC

Pa

Pressure

PSI

Bar

Temp

°F

°C

Percent

%

%