Braun 7510 Manual De Usuario

 

4

Our products are designed to meet the highest standards 
of quality, functionality and design. We hope you enjoy 
your new Braun shaver.

 

Only use the power supply cord set provided. 
A damaged cord must be replaced immediately.

 

1  Foil protection cap       7  Charging light 
2  Shaver foil

 (green)

3  Cutter block

8  Low-charge light 

4  Foil release button

 (red) 7520, 7515 only

5  Long hair trimmer

9  Pilot light

6  Switch

10  Shaver socket

 

• Wattage via cord set: 7 W
• Power supply via cord set: 100-240 V 

 

2

 

/50 or 60 Hz 

(automatic adaptation)

• Shaver input voltage: 12-24 V

 

• First charging: Using the power supply cord set, 

connect the shaver to the mains with the switch 
on position «0» and charge it for at least 4 hours 
(plug might get warm).

• Once the shaver is completely charged, shave without 

the cord until fully discharged. Then recharge to full 
capacity again  (subsequent  charges will take about 
1 hour).

• A full charge will give up to 50 minutes of cordless 

shaving time depending on your beard growth. 
However, the maximum battery capacity will only be 
reached after several charging/discharging cycles.

• Best environmental temperature range for charging is 

15 °C to 35 °C.

 

• The pilot light shows that the shaver is connected to 

the mains. 

+35

°C

+15

°C

 

5494460_S 4-14  Seite 4  Donnerstag, 25. Januar 2001  12:22 12