Bracketron MVM Multi Vehicle Mount MVM-45-05 Manual De Usuario
Picture 2
Picture 1
MVM MODIFICATION INSTRUCTIONS
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 2
Start by fl attening the 90 degree bend that is on the MVM. Place the
MVM on a fl at hard surface. Your Bench Vice should have a hard fl at
spot for this purpose. Use the hammer to pound the bend fl at.
spot for this purpose. Use the hammer to pound the bend fl at.
With a Tin Snips, cut the MVM to the shape and dimensions as
shown in picture 2.
Place the MVM in a vice and bend a 90 degree angle on the
mount .5” past the second hole on the back of the mount. Bend
it with light fi nger pressure. Finish the 90 degree bend with a
hammer to square up the angle.
Go back to Step 4 on page 1 to complete the installation.
5
6
7
The Bracketron MVM-45-05 mount is a modifi able mounting bracket. The illustrations on the left show how this mount should
look during and after the modifi cation steps in order to fi t the listed vehicles on the front page of this manual.
Many vehicle
applications may not require any modifi cations to the mount. If this is the case it will be noted below and there will be no steps
to follow on this page.
PLEASE NOTE
© Bracketron Inc, 2006 All rights reserved.
The information in this document is subject to change without notice. Bracketron Inc. assumes no responsibility for any errors that may appear in this document nor
do we assume any liability in connection with its use. This supersedes and voids all previous literature. Please contact the sales department for additional information.
Bracketron Inc will not be responsible or liable for damage to vehicles in the installation and or removal of this Bracketron Inc mount. Bracketron Inc will not be liable
for personal injuries or damage to property resulting from a motor vehicle accident and or improper installation of this Bracketron Inc mount.
Note:
Please see page 3 in this manual for PHS-
203 Ultra Slim Swivel Instructions.
Bracketron Inc
5249 West 73rd Street, Suite G, Edina, MN 55439
tel:
952-746-7775
fax:
1-800-660-1784
toll free:
1-866-237-4443
email:
sales@bracketron.com
web:
www.bracketron.com
Flatten Mount Here with Hammer
Picture 3
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
Snip Mount as Shown Above.
2.5”
.5”
.5”
.5”
Bend Mount 90 Degrees.