Bracketron MVM Multi Vehicle Mount MVM-45-05 Manual De Usuario

MVM Instructions | 

IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-

tage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic parts of a vehicles 

dash. 

Unnecessary force or pressure can cause pieces to crack or break.

PARTS INCLUDED: MVM-45-05 Mount, 3 - #8x3/4” Self Tapping Screws, 2 - M4x8 Phillips Pan Head Screws, 2 - M4 Nylon Stop 

Nuts, PHS-203 Ultra Slim Swivel and Mounting Hardware. 

TOOLS NEEDED FOR MVM MODIFICATION (if required)

4 inch Mounted Bench Vise 

12 oz. Ball Pein Hammer 

Standard Tin Snips 

Standard Hacksaw

Small File

Dash Trim Tool (Part #SIT-104)

Two Sets of Audi Radio Removal Tools (Part #SIT-102)

5/16” Socket and Drive

9/32” Open End Wrench (for swivel)

Marking Pen

Locate the four slots on the face of the radio. Insert the Audi DIN tools in 

these four slots until you hear a click or lock. Note: There is a rubber 

seal that wraps around the radio between the radio and the dash pad. 

This causes the radio to sit very tightly in the cavity. To loosen this seal 

and allow the radio to slide out easier, we recommend using a Dash Trim 

Tool to wedge between both the right and left sides of the radio dash 

pad. Carefully wiggle the tool to loosen the radio slightly.

Grasp the four DIN tools and slide the radio out of its cavity just enough 

to allow access to the one (1) 5/16” hex head bolt that holds the climate 

control in place. Caution: Do not disconnect the radio. You will need the 

radio code to re-program it. Place a clean cloth over the shifter knob.  Set 

the radio on the shifter knob so it is out of the way.

Skip to Step 5 on the following page if you have not yet formed the 

bracket to fit your vehicle.

Remove the top right 5/16” hex head bolt that holds the climate con-

trol in place. Place the mount over the screw hole. Replace the bolt and 

tighten with the 5/16” socket and driver. 

Carefully reinstall the dash in reverse order securing all screws and clips 

to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi 

Vehicle Mount or any other AMPs compatible device.

Your installation is complete

Install Mount Here

  

Note:

 The hole pattern on the face of the MVM maybe 

different then what is shown in the pictures. 

Remove Bolt