Bunn iMIX-3 S Oatmeal Manual De Propietario

Descargar
Página de 8
4
INITIAL SET-UP
1.  Apply the four non-skid pads from the parts box to the bottom of the legs.
2.  Remove the drip tray assembly, drip tray bracket, and splash panel assembly from the parts box.
3.  Place a set of key holes in the drip tray bracket over the lower two screws in the panel below the hopper ac-
cess door; push down gently and tighten screws.
4.  Place the set of key holes in the splash panel over the upper two screws and position so the screws are 
between the holes.
ELECTRICAL REQUIREMENTS
WARNING - If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with 
a special cord available from the manufacturer or its service agent in order to avoid a hazard.
CAUTION - The dispenser must be disconnected from the power source until specified in Electrical Hook-Up.
The 120 volt version of this dispenser has an attached cordset.
Refer to the dispenser’s dataplate for exact voltage requirements.
44910.1 070912
ELECTRICAL HOOk-UP
CAUTION – Improper electrical installation will damage electronic components.
1.  An electrician must provide electrical service as specified.
2.  Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.
3.  Open the front door of the dispenser and place the heater switch in the “OFF” (upper position).
4.  Connect the dispenser to the power source. 
5.  If plumbing is to be hooked-up later be sure the dispenser is disconnected from the power source. If plumb-
ing has been hooked-up, the dispenser is ready for Initial Fill & Heat.
CE REQUIREMENTS
• This appliance must be installed in locations where it can be overseen by trained personnel.
• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe operation.
• An electrician must provide electrical service as specified in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental 
capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of 
this appliance by a person responsible for its safety.
• Children should be supervised to ensure they do not play with the appliance.
 If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with 
a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.
• Machine must not be immersed for cleaning.
220-240V AC 
single phase models
Note: This electrical service 
consists of 2 current carry-
ing conductors (L1 and L2) 
and a separate conductor 
for earth ground.
GREEN
GREEN
220-240V. A.C.
BLK
WHI
L1
L2
GRN/YEL
GRN