Vulcan-Hart Home Heaters Manual De Usuario

 

Copyright 2005                                                                                    

35

Vulcan V SERIES 

 Owner’s Manual 

Canadian Comfort Industries                                      

                                                    

Wall Thermostat 

(option)

 

A 24 volt wall thermostat and 25 feet of 18 gage thermostat wire is included in your heaters accessory package. It is 
recommended that the thermostat and thermostat wire be installed by an authorized 

VULCAN “V” Series

 dealer. 

 

¼” Hex Nutsetter & Driver 

 

Wirestripper 

Smaller size Flat Head Screwdriver 

1.  Unplug stove power cord from the wall outlet. 
2.  To gain access to the inside of the stove, remove the six x ¼” hex screws from the slotted back access 

panel. 

3.  Unscrew the control board from the side of the heater.  2  x ¼” hex screws. 
4.  Locate the thermostat terminal block, marked T’STAT INPUT, found on the back of the board (see figure 

31). 

5.  Be sure to run the thermostat wires through one of the slots of the rear access panel, before connecting the 

wires. 

6.  Connect the two wires from your thermostat to the terminals (one per terminal).  Ensure the wires are firmly 

connected. 

7.  Connect the two wires at your wall thermostat to their terminals.  Ensure these are firmly connected. 
8.  Remove the black two prong jumper, (see figure 32), located on the front, left hand side, near the bottom 

corner and reconnect it to only one of the posts. (see figure 33). 

9.  Reinstall the control board and the slotted rear access panels. 
10.  Plug in the stove and you are ready to operate with your thermostat! 

figure 31 

 

 

figure 32 

 

 

figure 33 

        figure 34