Vulcan-Hart Home Heaters Manual De Usuario

 

Copyright 2005                                                                                    

36

Vulcan V SERIES 

 Owner’s Manual 

Canadian Comfort Industries                                     

                                                     

Access
Panel

1

2

3

4

5

6

 
You would have found this along with your Owner’s 
Manual, video and inspection card.  This can have two 
purposes.  The main one is to be an attachment to the 
side of the hopper to help with cleaning out the hopper. 
The second purpose would be used as a dust pan for 
your shop. 
 
Keep this separate till needed. 
 

 

Should you find in necessary to remove the pellets from your hopper, for any reason, this handy attachment will 
save time and a lot of effort. 

 

¼” Hex Nut setter & Driver   or  Flat Head Screwdriver 
Pail or bin 

 

1.  Unplug the appliance power cord from the wall outlet. 

 

2.  To gain access to the inside of the appliance, remove the 

¼” hex screws from the LEFT HAND SIDE PANEL 
(looking from the front of the heater).  These are located 
on the back left hand side corner of the appliance. 

 

3.  Remove the panel simply by sliding it back toward the 

exhaust. 

 

4.  Remove the 2 – ¼” hex screws, labeled  A & B. 

 

5.  Install the Hopper Drop Chute, re-installing the screws. 

 

6.  Remove the  5 - ¼” hex screws from the side hopper 

access panel.  Number 1 – 5 (see picture) 

 

7.  Loosen the #6 screw, but leave it attached. This now 

allows the access panel to act as a door. 

 

8.  Place a catch pail under the drop chute. 

 

9.  Raise and lower the access panel as needed. 

 

10.  When finished cleaning out as many pellets as possible,  

re-install the 5 screws, remove the drop chute, replace 
the 2 screws and then install the side panel.