Snapper 1691765 Manual De Usuario
g. Using the front trunnion
I), connect the
cylinder and lift rod(G) to the tractor lift lever. (See
4.)
Position cylinder and insert short leg of
trunnion through it. Connect lift rod to long leg of
trunnion. Be sure lift rod is positioned with flat side
as shown.
trunnion. Be sure lift rod is positioned with flat side
as shown.
VIEWED FROM TOP
Figure 4.
2. For 18 hp models, Mfg. No. 1691307, and older, install
special washer (CC,
1) as follows:
a . Remove cotter pin (A,
5) and remove ground
speed control rod (B) from cam plate (C).
b. Install special washer (D) on control rod (B).
Reinstall rod to cam plate and secure with cotter
pin.
Figure 5. Special Washer Installation
A. Cotter Pin
Ground Speed Control Rod
C. Cam Plate
D. Special Washer
3. If a rear PTO has been installed on the tractor, it is not
necessary to install the
plate (0,
1). To
install, proceed as follows:
a. Remove and discard the rear-most screw from the
transmission support (figure 6).
b. Install the plate in mounting holes (C,
7)
shown. Use
hole
and
16-14
screw (E) at rear hole. Install
lockwashers and nuts.
Figure 6.
VIEWED FROM LEFT SIDE
Figure 7.
A. Lift Shaft Mtg. Holes
Hitch Mtg. Holes
C.
Mtg. Holes
7/16-14x
E.