Snapper 1691765 Manual Do Utilizador

g. Using the front trunnion 

 

 I), connect the

cylinder and lift rod(G) to the tractor lift lever. (See

 4.) 

Position cylinder and insert short leg of

trunnion through it. Connect lift rod to long leg of
trunnion. Be sure lift rod is positioned with flat side
as shown.

VIEWED FROM TOP

 

2. For 18 hp models, Mfg. No. 1691307, and older, install

special washer (CC, 

 1) as follows:

a . Remove cotter pin (A, 

 5) and remove ground

speed control rod (B) from cam plate (C).

b. Install special washer (D) on control rod (B).

Reinstall rod to cam plate and secure with cotter

pin.

A. Cotter Pin

 Ground Speed Control Rod

C. Cam Plate

D. Special Washer

3. If a rear PTO has been installed on the tractor, it is not

necessary to install the 

 plate (0, 

 1). To

install, proceed as follows:

a. Remove and discard the rear-most screw from the

transmission support (figure 6).

b. Install the plate in mounting holes (C, 

 7)

shown. Use 

 

 hole

and 

 16-14   

 screw (E) at rear hole. Install

lockwashers and nuts.

VIEWED FROM LEFT SIDE

A. Lift Shaft Mtg. Holes

 Hitch Mtg. Holes

C. 

 

 Mtg. Holes

 7/16-14x 

E.