Philips 8-bit microcontroller with two-clock 80C51 core UM10109 Manual De Usuario
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
User manual
Rev. 02 — 23 May 2005
23 of 133
Philips Semiconductors
UM10109
P89LPC932A1 User manual
level. When system power is removed V
DD
will fall below the minimum specified
operating voltage. When using an oscillator frequency above 12 MHz, in some
applications, an external brownout detect circuit may be required to hold the device
in reset when VDD falls below the minimum specified operating voltage.
applications, an external brownout detect circuit may be required to hold the device
in reset when VDD falls below the minimum specified operating voltage.
2.7 Oscillator Clock (OSCCLK) wake-up delay
The P89LPC932A1 has an internal wake-up timer that delays the clock until it stabilizes
depending to the clock source used. If the clock source is any of the three crystal
selections, the delay is 992 OSCCLK cycles plus 60
depending to the clock source used. If the clock source is any of the three crystal
selections, the delay is 992 OSCCLK cycles plus 60
µs to 100 µs. If the clock source is
either the internal RC oscillator or the Watchdog oscillator, the delay is 224 OSCCLK
cycles plus 60
cycles plus 60
µs to 100 µs.
Note: The oscillator must be configured in one of the following modes: Low frequency crystal,
medium frequency crystal, or high frequency crystal.
medium frequency crystal, or high frequency crystal.
(1) A series resistor may be required to limit crystal drive levels. This is especially important for low
frequency crystals (see text).
Fig 6.
Using the crystal oscillator.
Fig 7.
Block diagram of oscillator control.
002aab008
P89LPC932A1
XTAL1
XTAL2
quartz crystal or
ceramic resonator
(1)
÷2
002aaa891
RTC
CPU
WDT
DIVM
CCLK
UART
OSCCLK
I
2
C-BUS
PCLK
TIMER 0 AND
TIMER 1
HIGH FREQUENCY
MEDIUM FREQUENCY
LOW FREQUENCY
XTAL1
XTAL2
RC
OSCILLATOR
WATCHDOG
OSCILLATOR
(7.3728 MHz
±1 %)
PCLK
RCCLK
SPI
CCU
(P89LPC932A1)
32
× PLL
+20 %
−30 %
(400 kHz )